![]() Kit includes: Includes 2 terminating resistors (TR-120M-RD, TR-120F-RD), Powering it twice will cause damage to the Moduleġ) NMEA Starter kit: N2K-EXP-RD-2 (#124-69) If your boat has one of these on the network DO NOT power the NMEA power wires from either graph (LCX and LMS). This Power Node is hooked directly into a Tee in the network bus. Some boats come pre-rigged withe NMEA2000 network backbone from the boat manufacturer and may use a Power Node to supply power the network. (HDS units can not do this) If you are switching to all HDS units you have to buy the NMEA Power node to power the network, shown in the diagram below * if you are still using an older LMS or LCX unit which is networked to an HDS unit it can still power the nmea network through its power cable. ![]() The NMEA Network is totally expandable, just remove the terminator, add a Tee to plug in your new sensor and replace the terminator back on the new end. No NMEA Network is required unless you are using network sensors like temperature, fuel, interface cables or an external gps module. Please note if you are only interested in waypoint sharing all you need to do is connect the two HDS units with an Ethernet cable. If you are not hooking up an external antenna get rid of the extra Tee in the diagram. The Diagram below shows adding an external antenna, which is optional. Load Waypoints from MMC/SD Card on HDS Unitsįor more helpful hints check out this link too: Save Waypoints to MMC/SD Card on HDS Units ******** Lowrance How to video's.**********ĭoc Samson Lowrance HDS instructional DVD ![]() Link to Lei-Extra for Your source for Lowrance and Eagle accessories. ***Lowrance link to support and self support.****
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |